Loading ...
Loading ...
Loading ...
77
DE
EN
FR
NL
DA
NO
SV
FI
TR
EL
PL
CS
SK
SL
HU
HR
RO
RU
UK
BG
77
Using your steam generator
• Completely unwind the power cord and the steam cord from its storage space – 19.
• Lower the retaining hoop (depending on model) to unlock the safety catch – fig.3.
• Plug in your steam generator to an earthed socket.
• Press on the on / off switch. The green light (located on the control panel)
flashes and the boiler heats up – fig.15.
When the green “steam ready” light stops flashing (after 2 minutes approximately), the
a
ppliance is ready.
Use
Steam ironing
• Place the iron's temperature control slide according to the type of fabric to be
ironed (see table below).
• The iron’s light will come on. Important: whenever you start using your iron
and whenever you reduce the temperature during use, the iron is ready for use
when its indicator light goes out and when the green light located on the
control panel comes on and remains on. During use, when you increase the
temperature of the iron, you can start ironing immediately, but make sure you
only increase your steam flow once the iron’s light has gone out.
• Adjust the steam output control dial (located on the control panel).
• When the iron is in use, the iron thermostat light on the iron comes on and goes off according to the soleplate
temperature requirement without this having any effect on the use of the appliance.
• To obtain steam, press on the steam control button under the iron handle and keep it pressed – fig.10. The steam
will stop when you release the button.
• When starting, and regularly while it is being used, your steam generator's electric pump injects water into the
boiler. It makes a noise but this is quite normal. You may also hear a clicking noise which is the steam valve
opening. Again this is normal.
• Always spray starch onto the reverse side of the fabric to be ironed
Set the temperature and steam control
Check the garment label if you are not
sure what type of fabric it is made of.
• Iron temperature setting:
- Start with the fabrics to be ironed at a low temperature (•) and finish with those which need higher temperatures
(••• or Max).
- For mixed fibre fabric: set the ironing temperature to the setting for the most delicate fabric.
- Woollen garments: press repeatedly on the steam control button – fig.10 to obtain short bursts of steam, without
placing the iron on the garment itself.
• Steam output setting:
- Thick fabric: increase the steam setting.
- If you intend to iron at low temperature, set the steam control button to MINI and press the steam button
whenever needed.
• If you put your thermostat in the “min” position, the iron does not become hot.
MODE ECO:
Your steam generator iron has an ECO mode function which uses less power whilst still guaranteeing a
sufficient steam flow for you to iron your garments properly. In order to use this function, once the
thermostat of your iron has been correctly set (see table above), position the steam flow setting on the
ECO segment
- fig.17. Using the Eco mode will allow you to press fabrics at minimum temperature ••.
However, for very thick or wrinkled fabrics, we recommend using the maximum temperature in order to
guarantee best results.
Dry ironing
- Do not press the steam control button under the iron handle.
TYPE OF FABRICS
SETTING TEMPERATURE
CONTROL
SETTING STEAM OUTPUT CONTROL
DIAL
Linen, cotton
Silk, Wool
Synthetics
(polyester, acetate, acrylic, polyamide)
SETTING THE TEMPERATURE AND STEAM OUTPUT ACCORDING TO TYPE OF FABRIC TO BE IRONED:
Do not place the iron on a metal
support.When taking a break from
ironing, always place the iron on the iron
rest plate of the unit. It is equipped with
non-slip pads and has been designed to
withstand high temperatures. Always use
a vented/mesh ironing board and be
careful of hot steam when ironing close
to the edges of the board.
To prime the steam circuit, either before using
the iron for the first time, or if you have not
used the steam function for a few minutes, press
the steam control button several times in a row,
holding the iron away from your clothes. This
will enable any cold water to be ejected from
the steam circuit.
The first time the appliance is
used, there may be some fumes
and smell but this is not
harmful. They will not affect use
and will disappear rapidly.
1800129556 GV83XX-GV84XX E0 A11_110x154 25/03/13 14:43 Page77
Loading ...
Loading ...
Loading ...