Loading ...
Loading ...
Loading ...
11
BOSCH
11
Calc’n’Clean
Advanced
~ 2 h.
ºC
2
1
250 ml
25 ml
0,25 L.
x2
2
1
Cleaning the Boiler
To extend the life of your steam
generator and to avoid any build up of
scale, it is essential that you rinse out
the boiler after several hours of use
(approximately after 50 hours). If the
water is hard, increase the frequency.
Do not use descaling agents for rinsing
out the boiler, as they could damage it.
1. Check carefully that the appliance is
cold and unplugged for more than 2
hours, and that the water tank (1) is
empty.
2. Fix the iron to the stand by inserting
the tip of the iron into the front slot
and moving the xation lever (11)
against the heel of the iron.
3. Place your appliance on the edge of
your kitchen sink.
4. Unscrew the lter (12) and take it out.
To wash the lter, you may:
a. Place the lter under the water tap
and wash it up until calc residues
are removed. Squeeze the lter as
indicated in the picture 5.
b. Immerse the lter in tap water
(250 ml) mixed with a measure
(25 ml) of descaling uid.
The descaling uid can be obtained
from our Aftersales Service or
Specialist outlets:
Accessory code
(After-sales)
Name of accessory
(Specialist outlets)
311144 TDZ1101
5. Holding your steam generator in
upside down position, and using a
jug, ll the boiler (in the base unit)
with 1/4 litre of water.
6. Shake the base unit for a few
moments and then empty it
completely over a sink or bucket. To
obtain the best result, we recommend
that this operation is done twice.
Important: before re-closing, make
sure no water remains in the boiler.
7. Replace and tighten up the lter.
Automatic clean warning
(Model dependent)
Pilot light (6) will ash indicating that
boiler must be rinsed.
To reset the “Calc’n’Clean” counter,
switch the steam station off twice,
keeping it off for at least 30 seconds
each time.
(on → 30s off → on → 30s off → on)
Loading ...
Loading ...
Loading ...