Loading ...
Loading ...
Loading ...
19
Type 1 bulb
replacement
NOTE: Before replacing the bulbs, review
the light bulb information and WARNING
on page 18.
Replacing Type 1 bulbs located in lamps
behind the top pan in the fresh food
compartment and the bottom freezer basket
in the freezer compartment:
1. Disconnect power at the circuit breaker
or fuse box and allow the lamps to cool.
2. To access the lamps in the fresh food
compartment, remove the top pan.
See Drawer and Pan Removal section.
2. To access the lamps in the freezer
compartment, remove the bottom freezer
basket. See Freezer Baskets section.
3. On the back wall there is a curved light
shield. Grasp each end of the light shield.
Pull the shield toward you and the tabs
on the shield will release from the slots in
the housing.
4. Remove the glass above the bulbs by pulling
it straight out.
NOTE: Always follow bulb manufacturer’s
directions for handling and replacing bulbs.
5. Remove the bulb by holding the base and
pulling straight up. Replace with a new bulb.
6. Replace the glass by sliding it into place.
Then replace the light shield by resting the
top lip of the shield on top of the light
housing. Then press the sides until the tabs
pop into the slots in the housing.
WARNING: The light shield must
be replaced or the heat from the bulb could
damage the refrigerator.
7. Reset the circuit breaker or fuse box.
Light Shield
Loading ...
Loading ...
Loading ...