Loading ...
Loading ...
Loading ...
Page 7 of 9
REMOTE CONTROL
The remote allows the same functions to be controlled as the main control panel
on the air cooler.
Open the remote controller rear cover and install a CR2032 battery
The buttons have the same function as the main control panel
The remote has an effective control distance of 6 meters
CLEANING AND MAINTENANCE
ATTENTION: Please shut off the unit and unplug from the mains before
cleaning or performing any maintenance.
CLEANING THE SURFACE
Clean the plastic housing with a duster or a soft wet cloth.
Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause
irreversible damage. Make sure no water enters the control panel.
CLEANING THE WATER TANK
Unplug the power cord and remove the honeycomb filter bracket. With a cloth (dipped in a
mild detergent), wipe the water tank. Before using the unit, the tank should be rinsed by
filling the tank and allowing it to drain through the drain port.
Draining the water reservoir and refilling with fresh water at least once a week will help
reduce any mineral deposits and keep the filters clean.
Do not run the unit in Humidify mode with stale water in the tank.
We recommend emptying the tank and refilling it with fresh water if water has been
standing in the tank for an extended period of time.
MAINTAINING AND CHANGING THE HONEYCOMB FILTER PADS
The appliance is supplied with Honeycomb cooling / filters pads. The cleaning frequency for
the Honeycomb filter depends on local air and water conditions. In areas where the mineral
content of water is high (hard water), mineral deposits may build up on the honeycomb
cooling filter and restrict air flow. If mineral deposits remain on the Honeycomb pads, the
filter should be removed and washed under fresh water. For a deeper clean a mild
detergent should be used with a soft brush. Once cleaned the filter should be rinsed in
clean water before leaving to dry.
We recommend cleaning the honeycomb filter at least every two months, depending on your
needs.
For best results, allow the honeycomb filter to dry after each use by turning off the COOL
function and running the unit as a fan for 15 minutes before turning the unit off.
END OF SEASON MAINTENANCE
1. Empty the tank and clean it following the instructions above.
2. Clean the Honeycomb pad
3. Store the Icepack in the water tank
4. Cover the unit and keep it in a dry place.
Loading ...
Loading ...