Loading ...
Loading ...
Loading ...
18
MAINTENANCE
• Install the new spool so that the strings and slots align with the eyelets in the string head.
Thread the strings into the eyelets.
• Pull the strings extending from the string head so the string releases from the slots in the spool.
• Reinstall the spool retainer by depressing tabs into slots and pushing down until spool retainer
clicks into place.
Fig. 12Fig. 11
SPOOL
RETAINER
SPOOL
SPOOL
SPOOL
HOLE
WIND
CLOCKWISE
SLOTS
TABS
STRING REPLACEMENT (See Fig. 11 - 12.)
• Unplug the string trimmer.
• Remove the spool from the string head.
NOTE: Keep the spring attached to the spool. Remove any old string remaining on the spool.
• Cut two pieces of string, each being approximately 9 ft. (2.7 m) long. Use only .065 in. (1.65
•
around the upper part of the spool counterclockwise, as shown by the arrows on the spool.
the slot.
wound string and the outside edge of the spool.
•
• Replace the plastic retainer, spool, and the spool retainer. Refer to Spool Replacement earlier
in this manual.
Loading ...
Loading ...
Loading ...