Loading ...
Loading ...
Loading ...
Safety InformationOperating InstructionsTroubleshooting TipsCustomer Service
About the water softening system.
10
NOTE:
If
15
and
HARDNESS
(factory default) do not show in the
display, press
SELECT
until they do.
Press the UP or DOWN button to set your water hardness
number in the display. DOWN moves the display down to 1.
UP moves the display up to the maximum setting of 90.
NOTE:
Each press of a button changes the display by 1 between
1 and 25. Above 25, the display changes 5 at a time…25, 30, 35, etc.
Holding a button in changes the numbers twice each second.
When the water hardness number shows, press
SELECT
to set.
You can get the grains per gallon (gpg) hardness of your water
supply from a water analysis laboratory, or call and ask your
local water department, if you are on a municipal supply.
2
1
Set Water Hardness Number
NOTE: RECHARGE TIME
and a flashing
2:00 AM
(factory default)
should show in the display. This is a good time for regeneration to
start (over in about 2 hours) in most households because water is
not in use. HARD WATER is bypassed to house faucets during
regeneration. See the
Automatic Hard Water Bypass During
Regeneration
section.
Press the UP or DOWN button to set the desired regeneration
start time.
NOTE:
Each press of the buttons changes the time by one hour.
Holding the buttons in changes the time twice each second.
Be sure to observe the AM or PM as you did when setting
the time of day.
Press the
SELECT
button once more.
The display shows the present time of day and
RECHARGE
TONIGHT
.
2
1
Set Regeneration (Starting) Time
Loading ...
Loading ...
Loading ...