Loading ...
Loading ...
Loading ...
5
Setting up your TV
Setting up your TV
Some TV models are packaged with a detached
Table-Top Stand so you can mount your TV to a
wall right away. If you are not mounting the TV to
a wall, you will need to attach the Table-Top
Stand. You will need a Phillips screwdriver and
the supplied screws to complete the task. Look for
the attachment instructions provided with the TV.
Be sure to consider the following while setting
up your TV:
• Disconnect all cables when carrying the
TV.
• Carry the TV with the adequate number of
people; larger size TVs require two or more
people.
• Correct hand placement while carrying the
TV is very important for safety and to avoid
damage.
• Ensure your TV has adequate ventilation,
see page 13.
• For best picture quality, do not expose the
screen to direct illumination or sunlight.
• Avoid installing the TV in a room with
reflective wall and floor materials.
• If the TV is brought directly from a cold to a
warm location, or is placed in a very damp
room, or is placed in a room in which heating
has just been turned on, moisture may
condense on the surface or inside the TV.
Should this occur, turn off the TV and leave the
TV off until the moisture evaporates, and then
the TV can be used. If you notice moisture
condensation between the glass panel and the
LCD, turn on the TV and the condensation will
evaporate after the TV has warmed up.
Attaching the Table-Top
Stand
Refer to the supplied Table-Top Stand
instruction leaflet for proper attachment for
some TV models.
1 Gently slide the TV unit onto the
Table-Top Stand and align the screw
holes.
~
• Do not put stress on the LCD panel or the frame
around the screen.
• Be careful to not pinch your hands or the AC
power cord when you install the TV unit to the
Table-Top Stand.
2 Use the supplied screws to attach the
TV unit to the Table-Top Stand.
~
• If you use an electric screwdriver, set the
tightening torque at approximately 1.5 N·m
{15 kgf·cm}.
Except KDL-22EX308 model
KDL-22EX308 model only
(Continued)
Loading ...
Loading ...
Loading ...