Candy CDPX 5000 Dishwashers

User Manual - Page 9

For CDPX 5000.

PDF File Manual, 37 pages, Read Online | Download pdf file

CDPX 5000 photo
Loading ...
Loading ...
Loading ...
AUTOMATIC FAULT SIGNALS
17
Turn off the dishwasher, open the
inlet hose and reset the cycle.
Check if the drain tube is bent or if
the siphon or filters are clogged.
If the problem persists, contact
Customer Service.
Check if the drain tube is bent or if
the siphon or filters are clogged.
If the problem persists, contact
Customer Service.
Contact Customer Service.
Contact Customer Service.
Clean the filter plate.
If the problem persists, contact
Customer Service.
FAULTS CAUSE SOLUTION
E2 appears on the display and
the buzzer sounds.
E3 appears on the display and
the buzzer sounds.
E4 appears on the display and
the buzzer sounds.
E5 appears on the display and
the buzzer sounds.
E6 appears on the display and
the buzzer sounds.
E8 or Ei appear on the display
and the buzzer sounds.
No water (inlet hose closed).
The machine cannot drain water.
Water leak
Electronic temperature control fault.
Electronic control fault.
The water heating element is not
working correctly or the filter plate is
clogged.
The dishwasher is able to signal a series of faults in the display.
16
"DELAY START" button
Dishwasher start time can be set with this
button, delaying start from 1 to 23 hours.
Proceed as follows to set a delayed start:
Press the "DELAY START" button ("00"
will appear on the display).
Press the button again to increase the
delay in hours (each time the button is
pressed the delay is increased by 1 hour
to a maximum of 23).
To start the countdown press the "START"
button. At the end of the countdown, the
program will automatically start.
If you wish to see which programme has
been selected, press the "PROGRAMME
SELECTION" button.
Proceed as follows to cancel a delayed
start:
Hold the "START" button down for at
least 5 seconds.
At this point, a new program and option
buttons must be set to start a new
program as indicated in the "PROGRAM
SETTINGS" section.
Buzzer mute
The buzzer may be muted as follows:
With the dishwasher off, hold down the
"PROGRAMME SELECTION" button
for few seconds while simultaneously
pushing the "ON/OFF" button.
"b1” will appear on the display to indicate
that the buzzer is on.
Press the "PROGRAMME SELECTION"
button again "b0" will appear on the
display to indicate that the buzzer is off).
Wait for a buzzer to sound to indicate
that the settings were saved.
To turn the buzzer on again, follow the
same procedure ("b1" will appear on the
display to indicate that the buzzer is on).
WARNING!
To ensure the correct operation of
the anti-overflow safety device, it is
recommended not to move or to tilt
the dishwasher during operation.
If it is necessary to move or to tilt the
dishwasher, first make sure the
washing cycle is finished and that no
water is left in the tank.
Loading ...
Loading ...
Loading ...