Loading ...
Loading ...
Automatic Heat Sensor
<RXUKRRGLVHTXLSSHGZLWKDQDXWRPDWLF
thermostat. This thermostat is a device that will turn
on or speed up the blower if it senses excessive heat
above the cooking surface.
If your blower is not on, or if it is running at low speed,
the thermostat will sense excessive cooking heat,
override the normal blower control and turn the
blower on to high speed. The blower will run until the
temperature drops to normal operating level. The
blower will then automatically return to its original
setting.
Light Bulb Replacement Stainless Steel (on some models)
This hood uses an F20T12 fluorescent tube and an
FS-2 starter, which are available at most hardware
stores or home centers.
If the tube flickers or does not light, check the
prongs on the ends of the tube to make sure they
are properly seated in the tube holders.
If the tube continues to flicker or does not light,
replace the tube. Slide the tube into the holders and
rotate the tube so that the prongs in the holders
grip the tube and hold it in place.
If the ends of the tube light but the center does not,
the starter may require replacement. The starter
is located behind the filter panel on the right hand
side. Install the new starter by pushing the starter in
and turning it clockwise.
Do not use a steel wool pad; it will scratch the
surface.
To clean the stainless steel surface, use warm
sudsy water or a stainless steel cleaner or polish.
Always wipe the surface in the direction of the
grain. Follow the cleaner instructions for cleaning
the stainless steel surface.
To inquire about purchasing stainless steel
appliance cleaner or polish, or to find the location
of a dealer nearest you, please call our toll-free
QXPEHU
National Parts Center 1.800.626.2002
GEAppliances.com
Filter
Slide the glass visor open.
Open the filter panel
by turning the two clips and
allowing it to swing free.
Flex the filter in the middle
to remove it.
Wash and rinse the filter in a
mild detergent solution.
Replace the filter before using the exhaust fan.
Panel clip
Glass visor
Filter panel
Grasp filter
and bend to
remove
WARNING:
ALWAYS DISCONNECT ELECTRIC POWER SUPPLY BEFORE SERVICING HOOD.
CARE AND CLEANING
Use a mild detergent suitable for painted surfaces.
DO NOT USE ABRASIVE CLOTH, STEEL WOOL PADS
OR SCOURING POWDERS. Vacuum the blower to
clean it. Do not immerse the blower in water.
The glass visor assembly and light lens are easily
UHPRYDEOHIRUFOHDQLQJ
DO NOT clean in a dishwasher.
Remove the light lens by opening the filter panel and
turning the 2 metal clips holding the lens in place.
3
Loading ...
Loading ...
Loading ...