Loading ...
Loading ...
Loading ...
10
REVERSING THE DOOR SWING
1. Unplug the refrigerator and remove all items
including shelves and bins.
2. Remove the top hinge cover
and hinge and set them aside.
3. Open the freezer door
slightly and lift it off.
4. Lay the refrigerator on
carpet or on a blanket
on its RIGHT SIDE.
5. Turn the leveling legs clockwise until they are as far
down as possible without removing.
6. Remove the two screws
from base grille and
remove grille.
7. Remove the bottom hinge.
8. Open the fresh food door
slightly and lift it off.
9. Remove the center
hinge and discard the
washer. The washer
is needed only for
shipping.
10. Assemble the center
hinge on the left side.
NOTE: The center hinge
must be turned over as
shown when mounted on
the opposite side.
11. Slide the top socket of the fresh food door onto the
center hinge pin and close the door.
12. Assemble the bottom hinge on the left leg.
13. Replace the base grille.
14. Turn the leveling legs counterclockwise and stand
the refrigerator upright.
15. Lower the bottom socket of the freezer door onto
the center hinge pin and close the door.
16. Fit the top hinge pin into the socket at the top of the
freezer door, tighten the screws and replace the
hinge cover.
17. Move the vacuum break, if there is one on this
model. Carefully peel it from its original location
and install it on the other side. The vacuum break
makes the door easier to open (part WR02X8905).
Apply it to the flat metal surface at the top front of
the refrigerator case. It should be about 2 inches
from the edge on the hinge side of the refrigerator.
18. Remove the door handles
by removing the screws
under 2 plastic buttons.
Install the handles on the
opposite side.
Bottom
Hinge
Top
Hinge
Vacuum
Break
Vacuum
Break
2 Inches 2 Inches
Base Grille
Screw
Center
Hinge
Center
Hinge
Door
Handles
Washer
Loading ...
Loading ...
Loading ...