Loading ...
Loading ...
Loading ...
7
INSTALLATION INSTRUCTIONS
BEFORE USING YOUR APPLIANCE
Remove the exterior and interior packing.
CAUTION: After unpacking you MUST allow your appliance to stand upright for at least 2 hours to allow
the lubricant and refrigerant to drain back into the compressor and stabilize. Failure to do so may
adversely affect performance and the lifetime of the unit.
Clean the interior surface with lukewarm water using a soft cloth.
Install the handle on the door. (See page 9.)
INSTALLATION OF YOUR APPLIANCE
The appliances are designed for either built-in or free-standing installation.
WARNING: Do not store or install appliances beginning SCR1401, SCR1156, or SCR610 in the
outdoors. Model SCR611GLOS is rated for outdoor use.
CAUTION: This appliance is designed for storing and cooling beverages, including wines and
champagne. Do not store perishable food, medicine or other medical products.
Place your wine cellar on a floor that is strong enough to support it when it is fully loaded. To level the
unit, adjust the front leveling legs.
For freestanding installation, 5 inches (127 mm) of space between the back and sides of the unit are
suggested, which allows the proper air circulation to cool the compressor and condenser for energy
saving. Even for built-in installation, it is a must to keep 2 to 3 mm of space (about 1/10") on each side
and at the top, and 2 inches (51 mm) at the back, to ensure proper service access and ventilation. And
the air vent at the front of the appliance must never be covered or blocked in any way.
NOTE: It is recommended that you do not install the appliance near an oven, radiator or other heating
source. Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Don’t install in a location where the temperature will fall below 60°F (16°C). For best
performance, do not install the appliance behind a cabinet door or block the base grille.
Avoid locating the unit in moist areas.
Plug the wine cellar into an exclusive, properly grounded wall outlet. Do not under any circumstances
cut or remove the third (ground) prong from the power cord. Any questions concerning power and/or
grounding should be directed toward a certified electrician or an authorized service center.
ELECTRICAL CONNECTION
This appliance should be properly grounded for your safety. The power cord of this appliance is equipped
with a three-prong plug which mates with standard three-prong wall outlets to minimize the possibility of
electrical shock.
Do not under any circumstances cut or remove the third (ground) prong from the power cord supplied. For
personal safety, this appliance must be properly grounded.
This appliance requires a standard 115/120 Volt AC ~ 60Hz three-prong grounded electrical outlet. Have
the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded.
When a standard 2-prong wall outlet is encountered, it is your responsibility and obligation to have it
replaced with a properly grounded 3-prong wall outlet.
WARNING
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by a qualified electrician or an authorized service center.
Loading ...
Loading ...
Loading ...