Loading ...
Loading ...
Loading ...
7
To prevent accidental injury, the cord should be secured behind the appliance and not left exposed or
dangling.
The appliance should always be plugged into its own individual electrical outlet which has a voltage rating
that matches the rating label on the appliance. This provides the best performance and also prevents
overloading house wiring circuits that could cause a fire hazard from overheating. Never unplug the
appliance by pulling on the power cord. Always grip the plug firmly and pull straight out from the
receptacle. Repair or replace immediately all power cords that have become frayed or otherwise
damaged. Do not use a cord that shows cracks or abrasion damage along its length or at either end.
When moving the appliance, be careful not to damage the power cord.
EXTENSION CORD
Because of potential safety hazards under certain conditions, it is strongly recommended that you do not
use an extension cord with this appliance. However, if you must use an extension cord it is absolutely
necessary that it be a UL/CUL-Listed, 3-wire grounding type appliance extension cord having a grounding
type plug and outlet and that the electrical rating of the cord be 115 volts and at least 10 amperes.
INSTALLING THE STAINLESS STEEL HANDLE
This appliance includes a stainless steel handle that is not required
to operate the unit. To install the handle, follow the instructions
below:
1. Remove the door gasket (2) on the side you wish to install the
handle - you can see two designated holes for handle
installation.
2. Install the handle (4) tightly as shown here with two screws (1)
and flat washers (3) provided.
3. Replace the door gasket.
OPERATING YOUR APPLIANCE
It is recommended that you install the appliance in a place where the ambient temperature is between72º
and 78ºF (23º-26ºC). If the ambient temperature is above or below the recommended temperatures, the
performance of the unit may be affected. For example, placing your unit in extremely cold or hot
conditions may cause interior temperatures to fluctuate. The range of 36º-68ºF (2º-20ºC) may not be
reached.
CONTROL PANEL
ON/OFF Power
To turn the appliance off, press and hold the key for 5 seconds until the temperature display
goes off. To turn the appliance on, press and hold the key for 1 second until the temperature
display lights up.
Loading ...
Loading ...
Loading ...