Loading ...
Loading ...
Loading ...
Calc-Clean function
IMPORTANT: To prolong the lifetime of your appliance and to maintain
good steaming performance, use the Calc-Clean function once every
1 month. If the water in your area is very hard (i.e. when akes come
out of the soleplate during ironing), use the Calc-Clean function more
frequently.
1 Make sure the appliance is unplugged and the steam control is set
to (Fig. 14).
2 Fill the water tank to the MAX indication (Fig. 15).
Do not pour vinegar or other descaling agents into the water tank.
3 Plug in the iron (Fig. 16).
4
Unplug the iron when the ‘iron ready’ light turns steady on (Fig. 17).
5
Hold the iron over the sink. Push the steam slider to the Calc-Clean
position and hold it (Fig. 18).
6 Gently shake the iron until all water in the water tank has been used up.
Caution: While scale is ushed out, steam and boiling water also come
out of the soleplate.
7 Set the steam control back to .
Note: Repeat steps Calc-Clean process if the water that comes out of
the iron still contains scale particles.
After the Calc-Clean process
1 Plug in the iron. Let the iron heat up to let the soleplate dry.
2
Unplug the iron when the ‘iron ready’ light turns steady on.
3
Move the iron gently over a piece of cloth to remove any water stains
on the soleplate.
4
Let the iron cool down before you store it.
Storage
1 Unplug the iron and set the steam control to (Fig. 19).
2
Wind the mains cord round the cord storage facility and store the
iron on its heel (Fig. 20).
Troubleshooting
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, visit www.philips.com/support for a list of frequently
asked questions or contact the Consumer Care Centre in your country.
Loading ...
Loading ...
Loading ...