Loading ...
Loading ...
Loading ...
14 15
GETTING UP AND RUNNING
GETTING UP AND RUNNING
Changing the CR-V3 battery
Insert the battery.
• The CR-V3 battery must be inserted with the battery
terminals first. The flat side of the battery should face the
front of the camera. If the battery does not fit, check its
orientation. Never force the battery.
This digital camera uses one CR-V3 lithium battery. When replacing
the batteries, the mode dial should be in the off position.
1
2
Although performance is better with a CR-V3 lithium battery, two AA-size Ni-MH
batteries can also be used. Other types of AA batteries should not be used. When
using Ni-MH batteries, fully recharge them with a battery charger suitable for complex
electronic equipment. Please consult your vendor about an appropriate charger.
Installing AA batteries
Install the AA batteries as shown in the diagram; make
sure the positive and negative battery terminals are
oriented correctly.
Open the battery-chamber door by sliding the door toward the bottom
of the camera (1) to release the safety catch; the door can then be
opened open (2).
Close the battery-chamber door (3) and slide it toward
the top of the body (4) to engage the safety catch.
• After installing the battery, the set-time/date message may
appear on the monitor. The clock and calendar are set in
the custom 2 section of the setup menu (p. 96).
3
4
Always keep the strap around your wrist in the event that the cam-
era is accidentally dropped.
Attaching the hand strap
Pass the small loop of the hand strap through the strap eyelet on
the camera body (1).
Pass the other end of the strap through the small loop
and tighten (2).
1
2
An optional leather neck strap, NS-DG200, is also
available from your Minolta dealer.
Loading ...
Loading ...
Loading ...