Loading ...
Loading ...
Loading ...
LCS30 COCKTAIL STATION CARE & USE/INSTALLATION
|
5
1. Install the faucet or the stainless steel plug (included) into the top faucet opening.
2. Carefully lower the sink into the cut out on the counter top. Push the sink back unl there are no gaps in the
back and the bullnose contacts the front face of the cabinet. The sink will be supported by its weight on the side
and back.
3. If desired a small bead of silicone sealant could be put around the edges of the sink to prevent water seepage
into the spaces below the sink.
Assemble all drain pipe connecons to the tailpiece and on through a pipe trap and proper drainage. The drain
must be installed in accordance with all local codes. In the absence of local codes, the requirements of the Uniform
Plumbing Code should be followed.
INSTALLING THE SINK
INSTALLING THE DRAIN PIPING (NOT SUPPLIED)
INSTALLING THE TRANSFORMER
The power supply transformer should be installed below the sink within the cabinet enclosure. Select a locaon
where the transformer is protected against water, heat and physical damage. It is recommended that fasteners are
used in at least two of the four mounng holes for secure aachment.
The power supply transformer must be plugged into a properly grounded GFI equipped outlet, installed by a
qualied technician. The outlet of the transformer is plugged into the white Molex connector at the rear of the sink.
Please see the electrical diagram provided in this manual.
Faucet installation
instructions available
in the faucet box.
Loading ...
Loading ...
Loading ...