Loading ...
Loading ...
Loading ...
63
PROGRAMMING MODE - TEST MODE
ENGLISH
PROGRAMMING MODE - TEST MODE
Diagnostic tests: (display)
This program has been added for testing the washer and detecting errors.
Entering the test mode
Data Name
Button Display Description
Entering
the test
mode
1. Entering
programming mode
Insert service card (card type), turn on/off toggle switch
(Coin type).
2. Hot
Press the Hot button. Then appears in the display.
3. Start Enter the diagnostic test mode.
1.
According to pressing Start button, test move to the next step.
Number of times
the Start button is
pressed
Check Point Display
None
1 time Turns on all lamps and locks the door Displays 1U:XX, 1t:XX and 12:XX alternately (Version)
2 times Tumble Clockwise. rpm (42~50)
3 times Low Speed Spin rpm (550~650)
4 times High Speed Spin rpm (900~1000)
5 times Inlet valve for cold water turns on.
(Close the gravity drain valve.)
Water level frequency (255~)
6 times Inlet valve for hot water turns on. Water level frequency (255~)
7 times Inlet valve for atomizing turns on. Water level frequency (255~)
8 times Inlet valve for bleach turns on. Water level frequency (255~)
9 times
Tumble counter clockwise.
(Open the gravity drain valve.)
rpm (42~50)
10 times Turn on the heater Displayed XX
11 times Turns on all lamps.
Displays 1U:XX, 1t:XX and 12:XX alternately
12 times Button Checks.
13 times High Speed Spin rpm (900~1000)
14 times
PDA Signal Check this function is not applied in this machine
15 times
NOTE
• Make sure the drum is empty when a diagnostic test is performed. Do not use .
Loading ...
Loading ...
Loading ...