Loading ...
Loading ...
Loading ...
5
It is recommended that a separate circuit, serving only your kegerator, be
provided. Use receptacles that cannot be turned off by a switch or pull
chain. The fuse (or circuit breaker) size should be 15 Amps.
Recommended grounding method
For your personal safety, this appliance’s plug must be grounded. It is
equipped with a 3-prong power supply cord. To minimize possible shock
hazard, the cord must be plugged into a mating 3-prong wall socket and
grounded in accordance with the National Electrical Code as well as local
codes and ordinances. In the event of a malfunction or breakdown,
grounding will reduce the risk of electric shock by providing a path of least
resistance for electrical current.
• Plug your appliance into an exclusive, properly installed, grounded wall
outlet. Do not under any circumstances, cut or remove the third (ground)
prong from the power cord.
• Any questions concerning power and/or grounding should be directed
toward a certified electrician.
• This appliance requires a standard 110~120 volt, 60Hz electrical outlet
with three-prong ground.
• Do not use outlet adaptors. No other appliance should be plugged into
the same outlet. Be sure that the plug is fully inserted into the outlet.
Leveling the Kegerator
It is important for the kegerator to be leveled for optimum efficiency. It can
be raised or lowered by rotating the plastic sheaths around each of the
feet on the bottom of the machine. If you find that the surface is not level,
rotate the feet until the kegerator becomes level. You may need to make
several adjustments to level it.
1. If available, place a carpenter’s level on top of the product to see if the
kegerator is level from front to back and side to side.
2. To adjust the height of the kegerator, simply turn the feet (Right =
Lower / Left = Raise)
IMPORTANT: Kegerator should be level before installation
Installing the Guardrail
Snap the guardrail into the top of the cabinet’s guardrail pilot holes.
Installing the Co2 Cylinder Holder
Slide the Co2 cylinder holder onto the four pegs located on the back of
the cabinet. This holder is optional and only needed if you plan to have
the Co2 cylinder installed externally.
Note: A detailed
installation guide of all
the dispense kit
components may be
included with your
kegerator depending on
the type purchased.
Loading ...
Loading ...
Loading ...