12″
4″
LINE UP WITH
PREVIOUSLY
DRILLED HOLE.
B.
LINE UP WITH
PREVIOUSLY
DRILLED HOLE.
A.
164D3370P267
49-40336
03-03 JR
Printed in Korea
NOTE: IT IS VERY IMPORTANT TO
READ AND FOLLOW THE DIRECTIONS
IN THE INSTALLATION INSTRUCTIONS
BEFORE PROCEEDING WITH THIS
REAR WALL TEMPLATE.
This template is for locating the horizontal exhaust
cutout. Do not use this template for vertical or
recirculation exhaust.
1. Place the template flat against the rear
wall, aligning the circles A. and B. with the
corresponding holes previously drilled in the
rear wall for holes A and B of the wall plate.
2. With the template aligned to the holes, tape the
template to the rear wall.
3. Use a saber or keyhole saw to cut out the shaded
area F. through the rear wall.
4. Remove the template from the rear wall.
5.
RETURN TO AND PROCEED WITH THE
INSTALLATION INSTRUCTIONS.
3/8″ TO EDGE
F. CUT OUT FOR HORIZONTAL
OUTSIDE EXHAUST
CUT HOLE THROUGH REAR WALL FOR EXHAUST ADAPTOR
Darle vuelta a la hoja para consultar la
versión en Español.
REAR WALL TEMPLATE
CAUTION – IF EXHAUST ADAPTOR IS POSITIONED OUTSIDE
RECOMMENDED DIMENSION, GREASE-LADEN AIR WILL
DISCHARGE INTO HOUSE STRUCTURE.
30
″
MINIMUM WIDTH REQUIRED
Loading ...
