Loading ...
Loading ...
Loading ...
12
mIMPORTANT! NEVER USE:
• Bleach, chlorine products, and other corrosive chemicals
• Liquids containing solvents (e.g. paint thinners, gasoline,
oils)
• Tri-sodium phosphate products
• Ammonia products
• Acid-based products
These chemicals will harm the unit and will damage
the cleaning surface.
Shutting down
1. Make sure the pressure adjustable valve is closed. Turn
the switch to the OFF (0) position and unplug the power
cord from the outlet.
2. Turn o the water source.
3. Hold the trigger to release water pressure.
4. Disconnect the garden hose from the water inlet on
the unit.
5. Disconnect the high-pressure hose connection on the
trigger gun handle.
6. Release the trigger and engage the gun safety lock.
mWARNING! Turn o the water supply and squeeze the
trigger to depressurize the unit. Failure to do so could result in
personal injury due to discharge of high-pressure water.
Taking a break
If you are taking a break of two minutes or more between
cleaning tasks:
1. Engage the gun safety lock (Fig. 13).
2. Turn the switch to the OFF (0) position.
3. Unplug the power cord from the outlet.
Storage
mCAUTION! Always store your commercial pressure
washer in a location where the temperature will not fall
below 32ºF (0ºC). The pump in this machine is susceptible to
permanent damage if it freezes. FREEZE DAMAGE IS NOT
COVERED BY THE WARRANTY.
• Store the pressure washer indoors in a dry, covered area
where it is not subject to adverse weather conditions.
• It is important to store this product in a frost-free area.
• Always empty water from the hoses and the pump before
storing.
mCAUTION! The use of a pump protector is
recommended to prevent cold weather damage during storage
over the winter months.
Winterizing + long-term storage
If you must store your pressure washer in a location where
the temperature falls below 32ºF (0ºC), you can minimize the
chance of damage to your machine by utilizing the following
procedure:
• Disconnect all water connections.
• Turn on the pressure washer for a few seconds until the
remaining water in the pump exits. Turn o immediately.
• Do not allow the high-pressure hose to become kinked.
• Store the machine and accessories in a room that does
not reach freezing temperatures.
• Do not store near a furnace or other sources of heat that
may dry out the pump seals.
• Operate the pressure washer with non-corrosive/non-toxic
anti-freeze, a pump saver, or a pump protector before
storing for the winter.
mWARNING! Before reusing, completely ush the unit
out with clear water. Anti-freeze products can damage
paintwork, so you must ensure there is no anti-freeze left in the
system before using it again.
Maintenance
mCAUTION! Before working on the pressure washer,
disconnect the plug from the power supply socket.
Change Pump Oil
The pump was lled with standard 5W-40 synthetic oil at the
factory. Check the table below for compatible pump oil and
schedule of oil changes.
To change the pump oil, follow the instructions below.
1. Place a container under the pump for waste oil. Use a
wrench to loosen and remove the oil draining nut located
at the bottom of the pump (Fig. 17).
OIL TYPE
FIRST CHANGE
TIME
TIME INTERVALS
FOR CHANGING
Synthetic
5W-40 oil
50 hours Every 100 hours
Synthetic
10W-30 oil
50 hours Every 150 hours
Loading ...
Loading ...
Loading ...