Loading ...
Loading ...
Loading ...
7
4. ASSEMBLY INSTRUCTIONS
NOTE:
1. Gaskets shall be placed at both ends of the bolt (against bolt head and nut), as otherwise stated.
2. The initial assembly is to tighten all bolts and nuts by hand, and to tighten them with wrenches
when fully assembled.
3. Some spare parts have been pre-assembled in the factory.
4. This product is recommended for installation by more than two people.
STEP 1
1. The Smith guide rod (#3) is installed on the floor (#1) according to the diagram and fastened with
bolt (#28) and flat gasket (#37) respectively, and the shock absorber (#26) is installed in the
Smith guide rod (#3).
2. Install the flat connecting plate (#22) with bolts (#29), nuts (#39) on the floor (#1) respectively.
3. The installed floor (#1), the rear connection (#2), and the bolt (#30), the flat gasket (#37), and
the nut (#39) will be fastened with the bolt (#30), the flat gasket (#37) and the nut (#39).
Loading ...
Loading ...
Loading ...