Loading ...
Loading ...
Loading ...
Indoor Unit Installation
The wall you select should be strong and solid
enough to protect it from vibration.
NOTE:
These instructions do not cover all
installations. However, the typical installation will be
to secure the installation plate to wall studs 16² apart.
It is recommended that a stud finder be used to
locate the wall studs.
Measure the wall and mark the centerline. It is
also important to use caution concerning the
location of the installation plate—routing of
the wiring to power outlets is through the walls
typically. Drilling the hole through the wall for
piping connections must be done safely.
Mount the installation plate on the wall with
four type A screws. If mounting the unit on a
concrete wall, use anchor bolts.
Mount the installation plate horizontally by
aligning the centerline using a level.
Drill the piping hole with a 2
3
⁄
4
–3² hole core
drill. Drill the piping hole at either the right or
the left with the hole slightly slanted to the
outdoor side (see illustration below).
(See templates in the back of this manual for hole location relative
to the installation plate.)
NOTES:
■For right rear piping, draw a line in the direction of
the arrow marked “A” and make another line
extending from the bottom line of the installation
plate. The meeting point of the two lines is the
center of the hole.
■For left rear piping, draw a line extending left
from the bottom line of the installation plate.
This is the center line of any hole for the left rear
installation.
Indoor Outdoor
D
C
B
A
2
Installation plate
Type A screw
Left rear piping
Center
line
Hole
center
Installation plate
“A”
2
3
⁄
4
–3² dia. piping hole
Customer ServiceTroubleshooting Tips
Operating Instructions
Safety Instructions
Installation Instructions
Wall
0.2~0.3²
Indoor Outdoor
15
Loading ...
Loading ...
Loading ...