Loading ...
Loading ...
Loading ...
4
Problem Action
There is no air coming from the
hand dryer.
Check fuse/circuit breaker is working and that the
power is connected. Must be performed by a qualified
electrician.
Ensure that the air hose is securely attached to the
base of the tap and no leaks are present. Must be
performed by a qualified electrician.
Check that the sensor cable from the tap is securely
connected. Must be performed by a qualified
electrician.
TAP
Problem Action
Water is continuously coming from
the tap.
Ensure sensors are clean and free from any
obstructions.
There is no water coming from the
tap.
Ensure that the power and water supplies are turned
on and that the isolation valve is open. Must be
performed by a qualified electrician.
Ensure that the aerator is free from debris, remove and
clean/replace if necessary.
The water coming from the tap is
overly hot or cold.
Contact the Dyson Helpline.
If you have any further questions please contact the Dyson Helpline.
CLEANING
The hand dryer should be cleaned daily.
Follow these 2 simple steps to ensure the unit performs to its best and remains hygienic. Using
the wrong cleaning method or product may invalidate your warranty.
1. Fit the cleaning cap, and wipe all surfaces with a soft cloth and non-abrasive cleaner.
2. Clean the air inlet on the base of the motor bucket REGULARLY.
GENERAL ADVICE
All cleaning chemicals should be used exactly as indicated by the manufacturer’s
instructions (including appropriate dilution).
If a cleaning product is left on the machine for too long, a film will form.
Any chemicals intended for use should first be tested on an inconspicuous area to confirm
suitability.
Aside from cleaning chemicals, care should be taken to avoid any harmful fluids from coming
into contact with the unit, in particular oils and alcohol-based products.
Ensure that the plughole in your sink is free from blockages and that the water can drain freely.
CHEMICAL GUIDELINES
Many professional cleaning chemicals can be used. The following are some that are harmful to
the machine and should not be used. Use of these will invalidate your warranty.
Do not use:
Alcohol-acid mixes
Alcohol
Solvent /oil-based products
Quaternary ammonium
Alkali-bleach mixes
Foaming ingredients
Bleach or abrasive cleaners
Do not pressure wash
WATER GUIDELINES
This hand dryer has an IP35 certification.
Use of pressure washers can force water inside the casing.
Water damage caused by incorrect cleaning will invalidate your warranty.
SOLENOID REPLACEMENT GUIDELINES
It may be necessary to replace the solenoid on your hand dryer. If you suspect this is the case,
please contact the Dyson Helpline at 1-888-DYSON-AB.
When replacing the solenoid, the hand dryer must be disconnected from the mains electricity
and water supply. Failure to do so could lead to serious injury and/or damage to property.
FILTER MAINTENANCE
Regularly check the air inlet to ensure that it is free from dust and debris. Simply wiping the
inlet with a soft cloth should be sufficient to remove dust and debris.
If the air inlet gets clogged, further cleaning or a filter change might be required.
If required for high usage environments, a Dyson filter change kit provides everything needed
to change your unit’s HEPA filter on site. Contact the Dyson Helpline at 1-888-DYSON-AB for
more information.
Filter cleaning or replacement for your hand dryer can be carried out by carefully following
the instructions given in the filter change kit. If in any doubt, consult a qualified electrician or
contact the Dyson Helpline at 1-888-DYSON-AB for support.
SERVICING
If your hand dryer needs servicing, please call the Dyson Helpline at 1-888-DYSON-AB.
Also visit the website at www.dysonairblade.com
DISPOSAL INFORMATION
Please dispose of this product responsibly and recycle where possible.
CONFORMITY STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation, notwithstanding use by
the general public in commercial, business and industrial environments. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
– Consult the dealer or an experienced radio/TV technician for help.
Loading ...
Loading ...
Loading ...