Loading ...
Loading ...
Loading ...
26
CHANGING THE FILTER
Locating the Filters
Yourrefrigeratorisequippedwithwaterlteringsystem.
Thewaterltersystemltersalldispenseddrinking
water, as well as the water used to produce ice.
Water Filter
Thewaterlterislocatedatthetoprightsideofthe
fresh food compartment.
Ordering Replacement Filters
Toorderyourreplacementlters,pleasevisitouronline
store at www.frigidaire.com/store, by calling toll-free
at 877-808-4195, or by visiting the dealer where you
purchased your refrigerator. Frigidaire recommends
thatyouorderextralterswhenyourstinstallyour
refrigerator,andthatyoureplaceyourltersatleastonce
every six months.
Here is the product number to request when ordering:
PureSource Ultra
TM
Water Filter
Part #ULTRAWF
Replacing the Water Filter
Ingeneral,youshouldchangethewaterltereverysix
months to ensure the highest possible water quality.
Water Filter Status on the user interface prompts you
toreplacethelterafterastandardamountofwater
(200 gallons/757 liters for PureSource Ultra
TM
)
has
owedthroughthesystem.
If your refrigerator has not been used for a period of time
(duringmovingforexample),changethelterbefore
reinstalling the refrigerator.
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
orafterthesystem.Systemscertiedforcystreduction
may be used on disinfected waters that may contain
lterablecysts.
Test & certication results:
• RatedCapacity-200gallons/757litersfor
PureSource Ultra
TM
iceandwaterlter
• Ratedserviceow-.50gallonsperminute
• OperatingTemp.:Min.33°F,Max.100°F
• MaximumRatedPressure-100poundspersquare
inch
• RecommendedMinimumOperatingPressure:30
pounds per square inch
To replace your PureSource Ultra
TM
water
lter:
It is not necessary to turn the water supply off to change
thelter.Bereadytowipeupanysmallamountsofwater
releasedduringthelterreplacement.
1 Turn Off the ice maker power switch.
2 Removethelterbypushingontheend/faceofthe
lter.
3 Slidetheoldwaterltercartridgestraightoutofthe
housing and discard it.
4 Unpackagethenewltercartridge.Usingthe
alignmentguide,slideitgentlyintothelterhousing
until it stops against the snap-in connector at the
back of the housing.
5 Push rmly until the cartridge snaps into
place (you should hear a click as the cartridge
engages the snap-in connector).
6 Press a drinking glass against the water dispenser
whilecheckingforanyleaksatthelterhousing.
Any spurts and sputters that occur as the system
purges air out of the dispenser system are normal.
7 Afterllingoneglassofwater,continueushingthe
system for about four minutes.
8 Turn On the ice maker.
9 Press and hold the Water Filter button on the Ice
& Water Dispenser control panel for three seconds.
When the display changes from Red to Green, the
status has been reset.
The PureSource Ultra
TM
iceandwaterlter
systemistestedandcertiedtoNSF/ANSI
Standards 42 and 53 for the reduction of claims
speciedontheperformancedatasheet.
More about your Advanced Water Filter
NOTE
Whenorderingyourreplacementlter,pleasereorder
thesameltertypethatiscurrentlyinyourrefrigerator.
Loading ...
Loading ...
Loading ...