Greenworks GPW 2300 PSI ELECTRIC PRESSURE WASHER

Owner’s Manual - Page 24

For GPW 2300.

PDF File Manual, 57 pages, Read Online | Download pdf file

GPW 2300 photo
Loading ...
Loading ...
Loading ...
24
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Motor will not
start.
On/Off switch is in the “OFF”
(O) position.
Set switch to the “ON” ( | ) position.
Power cord is not plugged in. Plug in power cord.
Electrical outlet does not
supply adequate power.
Try a different outlet.
Tripped pressure washer circuit
breaker.
Allow to cool, and restart unit.
Power switch is ON however gun
trigger is not squeezed ON.
With power switch ON push in on the gun
trigger which will engage the AUTO ON switch.
Unit does not
reach high
pressure.
Diameter of garden hose is too
small.
Replace with a 1” (25 mm) or 5/8” (16 mm)
garden hose.
Water supply is restricted.
Check garden hose for kinks, leaks and
blockage.
Not enough water supply. Open water source fully.
Pressure Tip has not been
installed on wand assembly.
Add desired pressure tip to end of wand.
Water inlet lter is clogged. Remove lter and rinse in warm water.
Output pressure
varies high and
low.
Not enough inlet water supply.
Turn water on fully. Check garden hose for
kinks, leaks or blockage.
Pump is sucking air.
Check that hoses and ttings are airtight. Turn
“OFF” machine, and purge pump by squeezing
trigger gun until a steady ow of water emerge
through the spray tip.
Water inlet lter clogged. Remove lter and rinse in warm water.
Supply voltage below
minimum.
Verify that only the pressure washer is running
on this circuit.
Calcied gun, hose or power
spray tip.
Run distilled vinegar through detergent tank.
Motor buzzes
but fails to run.
Supply voltage below
minimum.
Verify that only the pressure washer is running
on this circuit.
System has residual pressure.
Turn unit “OFF”, squeeze trigger on spray
wand to release pressure, then turn unit “ON”.
Voltage loss due to extension
cord.
Unplug any extension cords attached and plug
the unit directly into the outlet.
Pressure washer not used for
long periods.
Call customer service.
Residual friction among
components. Unit might hum.
Disconnect water supply and power ON for 2
to 3 seconds, repeat couple times or until the
motor starts.
No water.
Water supply is OFF. Turn ON water supply.
Kink in the garden hose. Remove kink in garden hose.
Loading ...
Loading ...
Loading ...