Loading ...
Loading ...
Loading ...
subzero.com | 11
INSTALLATION
Completion
KICKPLATE INSTALLATION
Install the kickplate using the two screws provided. Refer to
the illustration below. The kickplate must be removable
for service. The oor cannot interfere with removal. Do not
cover the louvered section of the kickplate.
90° DOOR STOP
The door stop pins provided with the ice maker will limit the
door swing to 90°.
To install, open the door to approximately 80°. Insert one
stop pin into the top door hinge (pin enters from the bottom)
and the other stop pin into the bottom door hinge (pin
enters from the top). Refer to the illustration below. Check
for proper operation.
HINGE COVERS
Install the hinge covers once installation of the ice maker
is complete and the door stop pins have been installed
(if applicable). The knock-out in the hinge cover must be
removed if the 90° door stop is used.
Verify the hinges are free of dirt or grease before applying
the covers. To install, remove paper backing and apply the
hinge covers to each hinge. Attach the magnetic center
covers. Refer to the illustration below.
WARNING
Follow all city and state laws when storing, recycling,
or discarding unused refrigerators and freezers.
DOOR STOP PIN
90° door stop
KNOCK-OUT
Hinge covers
Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf &
Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.
All other trademarks are property of their respective owners in the United States and other countries.
Loading ...
Loading ...
Loading ...