Loading ...
Loading ...
Loading ...
V40BVCBK V40BVCS314
User Manual
5.
This
Vintec
Beverage
Center
is
front
venting.
The
cabinet
draws
air
from
the
front
and rear and expels through the grill under the door at the front. If a joinery kick
board is being placed in front of the Beverage Center, a grill of at least the same
width as the Beverage Center grill and with a minimum airflow allowance of
150cm2 must be installed into the kick board.
6.
This
unit
has
a
power
switch
located
on
the
control
panel.
Power
point
location
is
therefore not critical.
7.
This
unit
requires
a
standard
240
volt/10
amp
power
point.
8.
The
power
cord
is
1.9m
in
length
and
is
affixed
to
the
right
side
at
the
back
of
the
cabinet.
9.
As
with
most
appliances
of
today,
this
cabinet
has
sensitive
electronic
components
which are susceptible to damage by lightning and electricity supply faults. It is
therefore advisable to use a power surge protector to avoid problems of this nature.
10.
Please
see
detailed
dimensional
diagrams
in
the
preceding
pages.
Please
note:
The
preceding diagram is for the 85mm plinth recess models.
Further Instructions:
The location you have selected for your Beverage Centre should:
- be unencumbered and well ventilated;
- be well away from any heat source and direct sunlight;
- not be too damp (laundry, pantry, bathroom etc.);
- have a flat floor;
- have a standard and reliable electricity supply (standard socket to country standards,
linked to the ground). It is NOT recommended to use a multi-socket or extension lead;
- have a s
urge protector fitted to the electrical outlet;
- be away from the microwave;
Note: Certain microwave ovens do not have wave interference shield. When placed within
a 1 meter vicinity of the Beverage Center, they may affect the operation of the wine
cabinet.
- do not cover the glass door with any other kind of door - this unit CANNOT be
integrated behind joinery
Notes: Not complying with any of the above instructions may result in WARRANTY void.
Loading ...
Loading ...
Loading ...