Loading ...
Loading ...
Loading ...
6
Power
Airflow speed control
Remote control
Remote control docks magnetically.
Attach the remote control to the
top of the machine with the buttons
facing down.
To operate, point the remote control
toward the front of the base.
Each time the heating mode is selected, it
conducts a short calibration cycle. Airflow will be
automatically controlled during this cycle. Once
the calibration cycle is complete, it will revert to the
selected airflow speed.
Press and hold the power button to run
through the target temperatures.
Cooling mode
Press the blue cooling mode button to enter cooling mode. The
power button light will change from red to blue to indicate that you
have entered cooling mode. To adjust the airflow speed use the
airflow control button.
Heating mode
Press the red thermostat control button until the digital display shows
the target room temperature. The power button light will change from
blue to red to indicate that you have entered heating mode. The red
circle will disappear when the target room temperature is reached.
Once the target room temperature has been reached, the machine
will stop heating the air. If the room temperature falls below the target
room temperature, the machine will start to heat again.
Standby
ON/OFF
Sleep timer
Focused
mode
Oscillation
ON/OFF
Diffused mode
Thermostat
control
Airflow speed
control
Cooling mode
On first use, the machine will default to a
temperature 5°F higher than the detected
room temperature. Thereafter, the machine will
remember the last target temperature set.
Select the desired room temperature. Pressing the
large red button on the remote control increases the
target temperature by 1°F; the smaller red button
on the remote control decreases it by 1°F. The
machine will not operate in heater mode unless the
target temperature is above the room temperature.
Loading ...
Loading ...
Loading ...