Loading ...
Loading ...
Loading ...
10 11
Maintenance: Changing the Filtration Bag
SaniSeal
®
OPERATION : Your Oreck
®
vacuum includes a filtration bag equipped with the
SaniSeal
®
System. SaniSeal
®
automatically locks in allergens, dirt and debris each time you change
the bag.
IMPORTANT NOTE: To keep your vacuum running at optimal performance, make sure to
change the filtration bag when the contents reach the MAXIMUM FILL LINE. Overloading may
result in loss of air flow suction and decreased performance.
118
ENFONCEZ JUSQU’À
ENTENDRE UN BRUIT
PRESIONE HASTA
ESCUCHAR UN
CHASQUIDO DE SUJECIÓN
CAUTION VERY FINE MATERIALS, SUCH AS FACE POWDER OR CORNSTARCH MAY SEAL THE FILTRATION
BAG AND CAUSE IT TO BURST EVEN THOUGH IT IS ONLY PARTIALLY FULL. CHANGE OFTEN WHEN
CLEANING THIS TYPE OF MATERIAL.
1
Unzip the Filtration Bag Case
completely. Pull the cardboard
collar to release bag dock door
from filtration bag port. Bag dock
door will hinge downward.
3
Slide the cardboard collar
completely onto bag dock door.
2
Gently pull cardboard collar
upward out of the bag
dock. SaniSeal
®
will close
automatically.
4
Firmly push bag dock door with
both thumbs on indication points
until it snaps. Zip up the filtration
bag case completely.
WARNING
TO REDUCE THE RISK OF PERSONAL INJURY, UNPLUG BEFORE CLEANING OR SERVICING. DO NOT USE
VACUUM WITHOUT FILTRATION BAG IN PLACE.
Maintenance: Adjusting or Replacing Brushroll
NOTE: Your Oreck
®
unit comes with the brushroll assembled in the “NEW” position (multiple
notches showing on top edge). As the brushroll wears it can be adjusted for longer life.
NOTE: When rotating the black endcaps on the brushroll, make sure both endcap settings are the
same and face up when you insert the brushroll.
1
Lay the unit flat
to access the
power head nozzle.
Remove the 5 screws
to take off the
baseplate from the
power head.
4
Reassemble the
brushroll belt.
Reference the
Maintenance Section
on Checking and
Replacing the Brushroll
Belt for details.
2
Remove the brushroll
belt and brushroll from
the holding channels
inside of the power
head nozzle.
5
Manually spin the
brushroll to see that it
turns freely.
3
When worn, rotate both
plastic black endcaps at
the ends of the brushroll
to show a single notch
“OLD” position. Insert
back into the holding
channels of the power
head nozzle.
6
Replace the 5 screws
to secure the
baseplate to the power
head nozzle.
CONTACT OUR CUSTOMER CARE LINE
1-800-989-3535 (Mon-Fri 7 a.m. – 7 p.m. CST; Sat 8 a.m. – 4:30 p.m. CST)
WARNING
TO REDUCE THE RISK OF ELECTRIC SHOCK AND INJURY FROM MOVING PARTS - UNPLUG BEFORE
CLEANING OR SERVICING.
Loading ...
Loading ...
Loading ...