Loading ...
Loading ...
Loading ...
21
DOOR HANDLE INSTALLATION (optional)
Note: Figures in the user manual are only for reference. The actual product may differ slightly.
The refrigerator must be disconnected from the source of electrical supply before attempting the
installation of accessory.
Step 1: take out two plug pins from the door (Side of door open)
Step 2: Install the door handle to the door and fasten it with screws
Step 3: Cover screw caps of the handle into screw holes
*The picture above is only for reference. The actual configuration will depend on the physical product or
statement by the distributor
Door Space Requirements
The unit's door must be able to open fully as shown.
W×D≥902×1052mm
Levelling the Unit
To do this adjust the two levelling feet at the front of the unit.
If the unit is not level, the door and magnetic seal alignments
will not be covered properly.
Make sure that the foot touches the ground before use.
Look down from the top, clockwise and counterclockwise loosening,
tightening.
Loading ...
Loading ...
Loading ...