Loading ...
Loading ...
Loading ...
WARNINGS
Before performing any repair or operation, switch the
appliance off and close the gas tap.
The manufacturer declines all responsibility for any damage to
persons, animals or things caused by failure to observe the rules
indicated above. In case it is necessary to repair or replace the
inside components, act as follows:
WARNINGS
Isolate the cooker from the electricity supply before attempting
to replace the oven lamp.
The oven lamp used is of a special type withstanding high
temperatures. To replace it, act as follows: disassemble the
protecting glass (A) and replace the burnt lamp with one of the
same type. Reassemble the protecting glass.
Disassembly of the worktop must only be done by a qualified
service technician
DISASSEMBLE OF WORK-TOP
In case it is necessary to repair or replace the inside components,
act as follows:
Remove the grids, remove burners and flame-spreaders (see
fig. 13), unscrew the visible screws ā€œVā€ placed on the work-top
(see fig. 14). Disassemble the work-top by unscrewing the rear
screws ā€œAā€ (see fig. 15A or 15 B according to the models). In this
way it is possible to lift the work-top and to reach the inside
components.
11
Removal of oven door
In-depth cleaning of the oven becomes more convenient if the
door is remo v ed following th e i nstructions be l ow:
1 open the oven door completely.
2 flip the hinge hooks "A" outwards (see fig. 9B).
3 shut the oven door slowly until it reaches hooks "A", making
sure these are locked into slots "B" of the oven door, as shown
in fig. 9C. Remove the glass FIg. 9A (only for models where
present).
4 Using both hands, push the oven door lightly inwards, to enable
the door hinges "C" to come away from the slots "D" (see fig.
9D) and pull the door towards you until it is released from the
oven.
After cleaning it, reposition it correctly following the abovesteps
in the reverse order and flipping hooks "A" inwardsbefore you shut
the oven door (fig. 9E).
CAUTION:
Do not use rough or abrasive materials or sharp metal scrapers
to clean the glass doors of the oven since they may scratch
the surface and cause the glass to break.
Fig. 13
Fig. 14
V
AA
A
B
A
C
D
A
Fig. 9C
Fig. 9B
Fig. 9D
Fig. 9E
Loading ...
Loading ...
Loading ...