Philips HF3470/60 User Manual

Loading ...

Setting the alarm sound (HF3470 only)

See section ‘Menu functions’ above.

You can choose one of the following sounds:

- Radio (Fig. 16)

- Birds (Fig. 17)

- Beep (Fig. 18)

Snoozing

1 Push down the control lever to the bottom position when the alarm goes off. (Fig. 19)

, The lamp continues to be on at the selected intensity level, but the alarm sound stops. After

9 minutes, the wake-up sound is automatically played again.

Note: The 9-minute snooze time is xed. This time cannot be adjusted.

Note: If you push down the control lever with too much force, it may jump back to off position.

Alarm demonstration

If you want to get a quick demonstration (60 seconds) of the gradually increasing light level and

sound level, activate the test function of the appliance.

1 Push the control lever down to the bottom position for a few seconds until TEST appears on

the display (Fig. 20).

2 Push the control lever down again to stop the demonstration.

Note: The appliance continues to run the alarm demonstration until you push down the control lever

again. The test automatically stops after 9 hours.

Radio/volume (HF3470 only)

1 To switch on the radio, press the radio on/off button. (Fig. 21)

2 To select the desired radio frequency, press the menu + and - button. (Fig. 9)

Tip: To scan radio frequencies automatically, press and hold the menu + or - button for approx. 2 seconds.

Tip: To make sure you get a good radio signal, fully unwind the antenna and move it around until you

have found a position at which reception is best.

3 To switch off the radio, press the radio on/off button again.

Volume

1 To set the volume, press the volume increase or decrease button. (Fig. 22)

HF3470: You can choose a volume level between 1 and 20. HF3465: You can choose a volume

level between 1 and 10.

Note: The volume level you have selected is automatically set as the volume level for the alarm as well.

Setting the display brightness

1 Press the MENU button to enter the menu (Fig. 8).

2 Press the menu + or - button to select the display brightness menu (Fig. 9).

3 Press the SELECT button to enter the display brightness menu (Fig. 10).

4 Press the menu + and - button to change the display brightness (Fig. 9).

5 Press SELECT to conrm (Fig. 10).

ENGLISH10

Loading ...

Philips HF3470/60 Wake-up Light