Loading ...
Loading ...
Loading ...
20
OVEN
PROBLEM
POSSIBLE CAUSE
SOLUTION
Oven will not ignite
Takes up to three minutes to ignite.
No electrical power to the unit.
Gas not flowing to oven.
Igniter does not glow red
Wait three minutes.
Plug into a three-prong electrical outlet
that is properly grounded.
Check and re-set circuit breaker for the
wall outlet used for this unit.
Turn a top burner on. If top burner ignites,
call for service.
Make sure gas supply valve is on.
Call for service
Lazy flame – floats, larger
in size than normal
Low propane supply (for LP users)
Needs an air shutter adjustment
Fill the propane tank.
Turn on/off valve fully to on.
See Oven Burner Air Shutter Adjustment
instructions.
Lifting flame – well-defined
with visible inner core,
noisy, gap between burner
and flame
Incorrect regulator setting.
Air shutter adjustment
Set regulator to proper setting - Liquid
Propane or Natural Gas.
See Oven Burner Air Shutter Adjustment
instructions.
Oven light not on
No electrical power to the unit.
Oven light bulb burned out.
Plug unit into a three-prong electrical
outlet that is properly grounded.
Check and re-set circuit breaker for the
wall outlet used for the unit.
Replace with 40 Watt Appliance light bulb
only. See Replacing Oven Bulb
instructions.
Platinum only: Replace with 25 Watt.
Convection fan does not
turn
No electrical power to the unit.
Fan guard is obstructed or clogged.
Plug into a three-prong electrical outlet
that is properly grounded.
Check and re-set circuit breaker for the
unit.
When oven is cool, remove any
obstructions like baked-on food or
aluminum foil.
Call for service.
Lazy or lifting flame on the
power burner in the PowR
Oven™
Air shutter adjustment
It is recommended that a certified
BlueStar service provider adjust the air
shutter on your PowR Oven™.
To adjust the air shutter, make sure the
range is off and cool.
Remove screws (3-4) holding the kick
plate in place.
Locate air shutter and loosen the air
shutter set screw.
Rotate the air shutter left or right until the
desired flame is achieved. Retighten the
screw.
The flame should appear blue.
Loading ...
Loading ...
Loading ...