Loading ...
Loading ...
Loading ...
10
CONNECTING AND REMOVING BATTERY
IMPORTANT!
The battery pack is not charged when it is purchased. Before using the power tool for the first time, place
the battery pack in the battery charger and charge. Make sure to read all safety precautions, and follow the
instructions in the battery charger section.
To install the battery pack
To install the battery pack into the bottom of the handle, align the rails of the battery pack with the rails in
the handle and push the battery into the handle. To connect the battery, slide the battery pack fully
forward. Until the latch locks into place.
To remove the battery pack
Press the battery release button ,Slide the battery pack backward, and then pull or lift the battery out of
the tool .
WARNING:
Follow these instructions in order to avoid injury and to reduce the risk of electric shock or
fire:
• Replace the battery pack or the charger immediately if the battery case or charger cord is damaged.
• Verify that the battery pack is removed before inspecting, adjusting, or performing maintenance on
any part of the power tool.
• Read, understand, and follow the instructions.
OPERATING INSTRUCTION
SWITCH ON AND OFF
Press the lock-off button to the left. To switch on the power tool, press the
On/Off switch and keep it pressed (see fig.3).
To switch off the machine, release the On/Off switch. Then press the lock-off
button to the right again.
CONTROLLING THE STROKE RATE
Increasing or reducing the pressure on the On/Off switch enables stepless stroke-rate control of the
switched-on machine.
CAUTION: The required stroke rate is dependent on the material and the working conditions
and can be determined by a practical trial. Reducing the stroke rate is recommended when the
saw blade engages in the material as well as when sawing plastic and aluminum.
TEMPERATURE CONTROL /OVERLOAD PROTECTION
When the temperature of battery is too high and the machine switches off automatically.
• Switch the power tool off.
• Allow the battery to cool down before continuing to work.
When the power tool is blocked and switches off automatically.
• Remove the power tool from the workpiece.
• As soon as the blockage is corrected, the power tool will continue to work at the set stroke rate.
Lock-off button
On/Off switch
Fig.3
Loading ...
Loading ...
Loading ...