Loading ...
Loading ...
Loading ...
SB-1000 Pro
SUBWOOFER
CONNECTING & CONTROLLING YOUR SUBWOOFER
AC Power Cord Receptacle
On/Off Switch - Turns Subwoofer On/Off
High Level (Speaker Level) Inputs - This connection method is for 2-channel stereo applica-
tions where the integrated pre/pro/amplifier only has high level (i.e., speaker level) outputs.
3V-12V Trigger Input - This feature will automatically turn the subwoofer on/off when a
signal is sent to the trigger input from another component in the system (typically the
pre/pro or AV receiver). The other component in the system must be equipped with a trigger
output feature and requires a TS 1/8” mono cable (pictured below).
Unbalanced (RCA) Line Level Inputs
Unbalanced (RCA) Line Level Outputs
USB Type A Port - Used for Firmware updates and powering a USB device like the SVS Sound-
Path Wireless Audio Adapter.
[+] - Push repeatedly or long press to increase volume, raise the low pass frequency cut-off
or to set to LFE, or to increase Phase degree.
[
-
] - Push repeatedly or long press to decrease volume, lower the low pass frequency cut-off,
or reduce phase degree.
Auto/On - Press this button to select “ON” which keeps the subwoofer on continuously so it
will not go into Standby mode. The three center LEDs will be illuminated in “On” mode. Press
again for “Auto” and only the outer two of the above LEDs will be illuminated. The subwoofer
will go into standby after 10 minutes if there is no audio signal.
LOW PASS - Press this button to adjust the Low Pass Filter frequency to ensure a smooth
sonic transition and flat frequency response between the speakers and subwoofer. The right
most LED on the status bar indicates the subwoofer is in LFE mode.
LED Bar - Displays the level for Volume, Low Pass Filter Frequency, and Phase
PHASE - Press this button to adjust the phase.
VOL - Press this button to adjust the volume.
1/8” TS
MONO CABLE
1
2
4
3
5
6
7
8
9
11
10
12
13
14
Loading ...
Loading ...
Loading ...