Loading ...
Loading ...
Loading ...
en
6
Selecting language
The language in the display window
12
can be set from to . “Deutsch”
is the factory setting.
Language
Setting
Deutsch L:01
English L:02
Français L:03
Nederlands L:04
Italiano L:05
ÅËËÇÍÉÊÁ L:06
Español L:07
Português L:08
Svenska L:09
Norsk L:10
Suomi L:11
Dansk L:12
Türkçe L:13
PYCCÅ L:14
Polski L:15
Èe. L:16
Magyar L:17
Croatian L:18
Slovenian L:19
To change the language:
Open the door.
Switch on ON/OFF switch
1
.
Hold down programme button
A
and press START button
10
until the
digital display
3
is indicated.
Release both buttons.
Press programme button
A
until
the factory set value is indicated
on the digital display
3
.
“Deutsch” is indicated in the display
window
12
.
Press programme button
C
.
Each time the button is pressed,
the set value increases by 1; after
, the setting goes back to .
Press START button
10
.
The set value is saved.
Close the door.
Water softening system
To ensure good washing results,
the dishwasher requires soft water,
i.e. containing low amounts of lime,
otherwise white limescale will be
deposited on the utensils and inner
container.
Tap water above 7_ dH (from set value
) must be softened.
The water is softened with salt
(regeneration salt) in the water softening
system of the dishwasher.
The setting and therefore the required
amount of salt depends on the degree
of hardness of your tap water (see table).
Set
The amount of salt dispensed can be set
from
to .
Sal is not required at the set value .
Find out about the hardness value
of your tap water. Your water supply
company will assist you.
Set value can be found in the water
hardness table.
Open the door.
Switch on ON/OFF switch
1
.
Hold down programme button A
and press START button
10
until on
the digital display is indicated
.
Release both buttons.
The LED for button
A flashes and
the digital display displays the factory
setting
.
To change the setting,
press programme button C .
Each time the button is pressed, the set
value increases by one level; when the
value of
has been reached,
the display jumps back to
(off).
Press START button
10
.
The chosen setting has now been
stored.
Close the door.
Loading ...
Loading ...
Loading ...