Loading ...
Loading ...
Loading ...
Assembly
Loosen and remove the height adjustment collar from the top of the inner tube.
Place the decorative cap onto the pole and replace the height adjustment collar.
Then connect the pole assembly to the base with the 'L' shaped screw supplied.
Tighten until secure.
Slide the base decorative cap down over the assembly.
Take off guard lock nut from motor shaft.
Place the rear guard on the front of the motor housing. Line up the lugs on the front of the
motor housing with the holes in the rear guard. Ensure handle is at the top.
Screw on guard lock nut tightly to attach rear guard.
Place the fan blade on the motor shaft and secure it by tightening the fan blade nut.
Place the front grill and install the plastic ring around the grids.
Tighten the screw of the grid to set the ring.
Insert inner tube into fan control panel and
secure by tightening the large screw at the rear
Loading ...
Loading ...
Loading ...