Loading ...
Loading ...
Loading ...
19
10
Operating the Dishwasher
SHX4AP, SHX5AL, SHX6AP
To start the dishwasher:
• Open the door. Press the [ON/OFF] button.
• One of the wash cycle LEDs will be ashing. You can
now select a wash cycle.
• Press the [<] or [>] button to select the desired wash
cycle.
• Press [START] (LED stops ashing)
• Close the door to begin the cycle.
NOTE:
1. Rinse Agent LED will be illuminated if the unit needs
Rinse Agent.
2. If you close the door without pressing the start button
the unit will beep.
To cancel a cycle:
• Open the dishwasher door just far enough to expose
the control panel. Be careful of hot water splash out!
• Press and hold the [START/RESET] button until the
“Active” LED goes out.
• Close the door and wait for about 1 minute for the
dishwasher to drain.
• The unit will beep when done draining.
• Open the door and press the [ON/OFF] button.
• You are now ready to start a new cycle.
To enter the options mode (Rinse Agent setting,
Extra Dry Heat, Cycle Completion Signal):
• Door must be open. Press the [ON/OFF] button to
turn the unit on.
• One of the wash cycle LEDs will be ashing.
• Press and hold down the [>] button, then press and
release the [START/RESET] button. Now release the
[>] button.
• The "Clean" and one other LED will be ashing. You
are now in the options mode.
• Press [>] to select the option you would like to adjust.
If the "Clean" and "Rinse Agent" LEDs are ashing you
can adjust the Rinse Agent settings.
If the "Clean" and "Sanitized" LEDs are ashing you can
set the Extra Dry Heat.
To set the amount of Rinse Agent:
NOTE: If your glasses have spots on them, you need more
Rinse Agent. If your glasses have streaks, you need less Rinse
Agent.
Follow the prior instructions to enter options mode. With
the "Clean" and "Rinse Agent" LEDs ashing:
• Press the [<] button to change the amount of rinse
agent dispensed.
0 LEDs ashing --> Rinse Agent dispenser is OFF
1 LED ashing --> Lowest amount of rinse agent
2 LEDs ashing --> Medium amount dispensed
3 LEDs ashing --> Highest amount of rinse agent
• Press [START] to save your settings.
To turn Extra Dry Heat on or o:
With the "Clean" and "Sanitized" LEDs ashing:
• Press the [<] button to turn Extra Dry Heat on or o.
The wash cycle LEDs will illuminate when you press
[<] button.
0 LEDs ashing --> Extra Dry Heat is OFF
1 LED ashing --> Extra Dry Heat is ON
To set the Cycle Completion Signal:
With the "Clean", "Sanitized" and "Rinse Agent" LEDs
ashing:
• Press the [<] button to change the cycle completion
tone level. The wash cycle LEDs will illuminate when
you press [<].
0 LEDs ashing --> Cycle Completion Signal is OFF
1 LED ashing --> Low tone level
2 LEDs ashing --> Medium tone level
3 LEDs ashing --> Highest tone level
• Press [START] to save your settings.
You could be seriously scalded if you allow hot water
to splash out of the dishwasher. OPEN THE DOOR
CAREFULLY during any wash or rinse cycle. Do not fully
open the door until water noises have stopped.
WARNING
Depending on your model you will either have 4, 5 or 6 wash
cycles.
Loading ...
Loading ...
Loading ...