Loading ...
Loading ...
Loading ...
Version 09/12- Page 8
FIGURE 13
9. The chimney must be attached to the body of the rangehood, as indicated in FIGURE 12. The UPPER CHIMNEY COVER (C)
must be installed rst, then the LOWER CHIMNEY COVER (B) wraps around it. Both sections are secured to the wall under the
CHIMNEY MOUNTING BRACKETS (H). Secure the UPPER CHIMNEY COVER to the MOUNTING BRACKETS with the CHIMNEY
SCREWS (J). Secure the LOWER CHIMNEY COVER to the CANOPY SECTION (A) with the CHIMNEY SCREWS (J).
FIGURE 12
10. Turn the power supply on. Turn on blower and light. If the rangehood does not operate, check that the circuit breaker is not
tripped or the house fuse blown. If the unit still does not operate, disconnect the power supply and check that the wiring connec-
tions have been made properly.
USE AND CARE INFORMATION
This rangehood system is designed to remove smoke, cooking vapors and odors from
the cooktop area.
For Best Results
Start the rangehood several minutes before cooking to develop proper airow. Allow the
unit to operate for several minutes after cooking is complete to clear all smoke and odors
from the kitchen.
Cleaning
The metal grease lters should be cleaned frequently in hot detergent solution or washed
in the dishwasher. Stainless steel cleaner should be used on stainless rangehoods.
Abrasives and scouring agents can scratch stainless steel nishes and should not be
used to clean nished surfaces.
Replacing the Lamps
Purchase halogen bulb - (Max 20W, 12V, type G4 bi-pin bulb)
Before attempting to replace the lamps, make sure that the light switch is turned off, USE
CAUTION AS THE BULB MAY BE HOT.
Remove the snap-on lamp cover (as indicated in gure 13) by levering it from under the
metal ring, supporting it with one hand. Remove the halogen lamp from the lamp holder
by pulling gently. Replace the lamp with a new one of the same type, making sure that
you insert the two pins properly into the housings on the lamp holder. Replace the snap-
on lamp cover.
Loading ...
Loading ...
Loading ...