Loading ...
Loading ...
Loading ...
28
SETTING UP + INSTALLATION
Remove the polystyrene base and place the machine near its permanent position.
Carefully cut through the hose retaining clip at the rear of the
appliance (diagram 1).
Unscrews the two top screws A and remove the cover, sliding it
off horizontally (diagram 2).
Remove the cardboard protection.
Unscrews the two tie braces B on the crosspiece (with an H. 19
spanner) and remove the polystyrene spacers under it (diagram 3).
Please do not fit the 2 tie braces B again!
IMPORTANT: DO NOT REMOVE THE SPACERS ABOVE
THE CROSSPIECE.
Replace the cover with the two screws A.
Please ensure when fitting the table top the locating pins are
inserted correctly in their slots, positioned on the side of the
cabinet as shown in the diagram 4.
Lean the machine forward and remove the plastic bags
containing the two polystyrene blocks at the sides, pulling
downwards (diagram 5).
WARNING:
DO NOT LEAVE THE PACKAGING WITHIN REACH OF
CHILDREN AS IT IS A POTENTIAL SOURCE OF DANGER.
Apply the insulation sheet of corrugated material to the base as
shown in the diagram 6.
Level the machine by means of the front feet.
a) Turn the nut clockwise to release the screw adjuster on the foot.
b) Rotate the foot to raise or lower it until it stands firmly on the
ground.
c) Lock the foot in position by turning the nut anti-clockwise until it
comes up against the bottom of the machine.
A
B
C
1
B
C
3
4
A
2
5
6
Loading ...
Loading ...
Loading ...