Loading ...
Loading ...
Loading ...
26
CheckRPMSensor(requires
shroud removal)
RPM sensor should be aligned
with magnet and connected
to data cable. Realign sensor
if necessary. Replace if there is
any damage to the sensor or
the connecting wire.
Console shuts off (enters sleep
mode) while in use
Check data cable integrity All wires in the cable should be
intact. If any are cut or crimped,
replace cable.
Check data cable
connections/orientation
Be sure cable is connected
securely and oriented prop-
erly. Small latch on connector
should line up and snap into
place.
Check magnet position (re-
quiresshroudremoval)
Magnet should be in place on
pulley.
Check RPM Sensor Contact Customer Care for
further assistance.
Unit rocks/does not sit level Check leveler adjustment Leveling feet may be turned in
or out to level bike.
Check surface under unit Adjustment may not be able
tocompensateforextremely
uneven surfaces. Move bike to
level area.
Pedals loose/unit difficult to
pedal
Check pedal to crank connec-
tion
Pedal should be tightened
securely to crank. Be sure con-
nection is not cross-threaded.
Checkcranktoaxleconnection Crank should be tightened
securelytoaxle.
Clicking sound when pedaling Check pedal to crank connec-
tion
Remove pedals and reattach
fully.
Seat post movement Check locking pin Be sure adjustment pin is
locked into one of the seat post
adjustment holes.
Check adjustment knob Be sure knob is securely tight-
ened.
Loading ...
Loading ...