Loading ...
Loading ...
Loading ...
en
22
Changing the dust compartment filter
(Fig. 38)
Open the dust compartment lid.
Pull the FilterBag out by the grip on
the collar.
Open the blue filter frame fully and
remove the old filter. Hold by the
clean, unsoiled section to remove it.
Replace with a new dust compart-
ment filter (for motor protection).
Close the filter frame.
Insert the FilterBag into the blue
holder as far as it will go.
Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the Fil-
terBag when doing so.
When to replace the exhaust filter
Depending on the model, your vacuum
cleaner will come with one of the fol-
lowing exhaust filters (Fig. 09) as stan-
dard:
a AirClean
Replace this filter every time you start a
new packet of Miele FilterBags. An Air-
Clean exhaust filter is supplied with ev-
ery packet of Miele FilterBags.
b Active AirClean 50 (black)
c HEPA AirClean 50 (white)
Replace if the display for the exhaust fil-
ter change indicator is completely filled
with red (Fig. 14). This occurs after ap-
prox. 50 hours of operation which is
equivalent to about a year of average
use. The vacuum cleaner can still be
used.
However, the suction power will be re-
duced as will the effectiveness of the fil-
ter if it is not replaced in good time.
How to replace the AirClean filter
(Figs. 39 + 40)
Do not use more than one exhaust fil-
ter at a time.
Open the dust compartment lid.
Press the release catch on the filter
grille and open the grille until it clicks.
Grasp the used AirClean exhaust filter
by one of the clean, unsoiled sections
and take it out.
Replace it with a new AirClean ex-
haust filter.
If you wish to fit an Active AirClean
50 or HEPA AirClean 50 exhaust fil-
ter, see "Replacing one type of ex-
haust filter with another."
Close the filter frame.
Close the dust compartment lid.
Replacing the Active AirClean 50 and
HEPA AirClean 50 exhaust filters
(Figs. 41 + 42)
Do not use more than one exhaust fil-
ter at a time.
Open the dust compartment lid.
Lift the exhaust filter and remove it.
Insert a new exhaust filter, making
sure it goes in properly, then push it
down into position.
Press the TimeStrip exhaust filter
change indicator(Fig. 12).
Loading ...
Loading ...
Loading ...