Loading ...
Loading ...
Loading ...
(NOTE: Two Racks can be joined to make a longer rack. If you have
purchased a second rack wish to connect them, please refer to the next
page for additional information. Please recycle unused components.
1. Using a Rubber Mallet or similar tool, install the #6 CAPS into the top
of BOTH of the #1 MAIN FRAMES as shown in Fig. 1. IMPORTANT: If
the caps are cold. please let them acclimate to room temperature
before installation or they may be damaged during installation.
2. By hand, install the four #5 RUBBER FEET onto both of the #1 MAIN
FRAMES as shown in Fig. 1.
3. Start by LOOSELY installing one of the #2L LOW DUMBBELL
TIERS in the bottom set of holes of both of the #1 MAIN FRAMES.
IMPORTANT: Please take care to install the #3 BACKING PLATES
onto the outside of each of the #1 MAIN FRAMES.
4. LOOSELY install the second #2L LOW DUMBBELL TIER in
the middle set of holes as shown in Fig 2.
5. LOOSELY install the #2T TOP DUMBBELL TIER. Please refer to
page 3 for the installation choices. In the drawing below we are
installing it at an angle. For flat use the rear upper hole.
TIGHTEN ALL BOLTS AT THIS TIME!
Assembly is Complete!
1
6
5
5
FIG. 1
FIG. 2
1
2L
2L
2T
3
3
7
8
7
8
7
8
7
8
7
8
8
9
8
9
8
8
9
9
8
9
8
9
8
9
7
8
3
3
3
3
7
7
8
8
7
7
8
8
7
7
8
8
1
8
9
8
9
ASSEMBLY
4
Loading ...
Loading ...
Loading ...