Pro-Ject STEREOBOXS2SIL Stereo Box S2 Silver High End Integrated Amplifier

User Manual - Page 4

For STEREOBOXS2SIL.

PDF File Manual, 4 pages, Read Online | Download pdf file

Loading ...
Loading ...
Loading ...
© Pro-Ject Audio Systems · Pro-Ject Stereo Box S2 · Revision 2018.10.25
4
Troubleshooting
No music from my speakers:
- make sure power cables, audio interconnects and speakers are correctly connected to Stereo Box S2
- make sure volume level is properly set
- make sure the correct input is selected
Technical specifications Pro-Ject Stereo Box S2
Output power: 2 x 25W / 37W @ 8 / 4 ohms (both channels driven)
Frequency response: 20Hz - 20kHz (+ 0dB, - 0,5dB)
Signal to noise ratio: >85dBA / >75dB (IEC -A)
THD: <0,1% at 20W / 4 Ohms; < 0,05% at 10W /8 Ohms
Gain: 32dB
Line level inputs: 2 pair RCA, 1 x 3.5mm jack
Input sensitivity: 350mV
Input impedance: 25k ohms
Variable out: 3.5mm jack
Speaker connectors: 4mm banana plugs, spades connectors or naked wire
Outboard power supply: 20V/3A DC, 100 - 240V, 50/60Hz
Power consumption: 3A DC, <1W in standby
Replacement battery remote control: 1 x CR2032 / 3V or 1 x CR2025 / 3V
Dimensions: W x H x D (D with sockets): 103 x 37 x 115 (125) mm
Weight: 422g without power supply
Service
Should you encounter a problem which you are not able to alleviate or identify despite the above information,
please contact your dealer for further advice. Only if the problem cannot be resolved there, the unit should be
sent to the responsible distributor in your country.
Warranty
The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use. Modification or changes to any part of the product by unauthorized persons release the
manufacturer from any liability over and above the lawful rights of the customer.
Copyright, trademarks
Pro-Ject Audio Systems is a registered Trademark of
H. Lichtenegger.
This guide was produced by: Pro-Ject Audio Systems
Copyright
©
2017. All rights reserved.
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.