Loading ...
Loading ...
Loading ...
Installation: Water & Drain
Water Supply, all models: The recommended water
supply tubing is ¼ inch OD copper. Stainless steel
flex or reinforced PVC tube may also be used.
Install an easily accessible shut-off valve between
the supply and the unit. This shut-off valve should
not be installed behind the unit.
Note: Do not use self-piercing type valves.
1. Remove the front service panel.
2. Route the
tubing through
the right hole in
the back to the
inlet water
solenoid valve
inlet.
3. Install a
compression fitting
on the tubing and
connect to the inlet
of the solenoid at
the front of the unit.
Note: Water Connection is at the FRONT of the
machine. Do NOT connect to tubing at the back.
Drains
There are two types of ice machine models, one
that drains by gravity and one that has an internal
drain pump.
Drain Pump Model drain installation
1. Locate the coil of 3/8” ID plastic drain tubing
secured to the back of the unit.
2. Route the plastic drain tube from the back of the
unit to the drain connection point.
The drain connection point can be as high as 10
feet above the ice machine. The drain pump
includes a check valve to prevent re-pumping water
in the drain hose.
IMPORTANT NOTE: Often an air gap is required by
local codes between the ice maker drain tube and
the drain receptacle.
September 2011
Page 9
SCCG50 & SCCP50
Installation and User's Manual
Back View, Drain Pump Model
Water Inlet
Tube (field
supplied)
Drain Tube,
Route to
building drain
Screw Securing
Front Service
Panel
Loading ...
Loading ...
Loading ...