Loading ...
Loading ...
Loading ...
10 INSTALL GRILLE PANEL
• Raise the grille panel to the stop position.
• Remove 4 screws on bottom trim; retain
all screws.
• Remove bottom trim.
• NOTE: Stainless steel and acrylic panels are
covered with a protective film. Remove the film
before installing the panel.
• Slide panel over the metal backer panel and
under the trim.
• If necessary, tap with a wood block until panel
slips under the top trim piece.
• Reassemble bottom trim. Tighten screws.
Raise
Grille
Panel
8 SECURE REFRIGERATOR
TO CABINETS
Whenever possible, perform this step for anti-tip
security or when anti-tip brackets cannot be used.
The refrigerator must be secured to prevent
tipping.
• Raise the grille panel to access case trim.
• Drill a hole in the trim and drive a screw through
the trim into the adjacent cabinet.
• Follow the same procedure on the opposite side.
Drive Screws
Through Case Trim Into
Adjacent Cabinets
Raise Grille Panel
to Stop Position
9 ADJUST DOOR SWING
NOTE: This refrigerator has a 2-position door stop.
When space does not allow the door to swing open
fully to 130°, you may change the door swing to
a 90° opening.
SKIP THIS STEP IF DOOR OPENING IS
SATISFACTORY FOR YOUR INSTALLATION
SITUATION.
• Open the door to view the bottom hinge.
Note the door stop pin location. The pin is factory
installed in the 130° position.
• Partially close the door. From above, use
a flat-head screwdriver to unscrew the door
stop pin and reinstall into the 90° position.
90
130
Hinge
Door
Interior
Installation Instructions
36
Loading ...
Loading ...
Loading ...