Loading ...
Loading ...
Loading ...
21
ow to use washer
H
Tub Clean
Tub Clean course can be set by pressing
and holding Intensive and Pre Wash button
simultaneously.
When Tub Clean course is set, display
“ ”, and all buttons are inoperable.
TUB CLEAN is special cycle to clean the
inside of the washer. This cycle uses higher
water level with higher spin speed. Perform
this cycle regularly.
How to use the Tub Clean cycle:
1. Remove any clothing or items from the
washer and close the door.
2. Open the dispenser drawer and add Anti
limescale (Calgon) to the Main wash
compartment.
NOTE: Do not add any detergent to the
detergent compartments. Excessive
suds may generate and leak from the
washer.
3. Close the dispenser drawer slowly.
4. Power On and then press and hold
Intensive and Pre Wash button for 3 seconds.
then
“ ”
is displayed in LED
5. Press the Start/Pause button to start.
6. After the cycle is complete, leave the door
open to dry around the washer door
opening, flexible gasket and door glass.
CAUTION: If there is a small child, be
careful not to leave the door
open for too long.
!
1. Spin selection
2. No spin ( )
3. Spin Only
Spin
• Spin speed is available according to the
program as follows.
- Cotton & Quick 30 & Rinse+Spin
No Spin – 400 – 600 – 800 – 1000 – 1200
– 1400
- Synthetic & Hand Wash/Wool & Duvet &
Baby Care
No Spin – 400 – 600 – 800 – 1000
- Delicate
No Spin – 400 – 600 – 800
• If “No Spin” is selected, the washer stops
after draining water.
1. Press the Power button.
2. Set the desired spin speed by turnning
spin dial.
3. Press the Start/Pause button.
The required lamp will light up for
identification.
• By turning the Spin dial, the spin speed can
be chosen.
Loading ...
Loading ...
Loading ...