Loading ...
Loading ...
Loading ...
1312
General Information
Installation
READ AND FOLLOW ALL WARNING
AND CAUTION INFORMATION
WHEN INSTALLING THIS APPLIANCE.
• All openings in the wall behind the
appliance and in the floor under the
appliance must be sealed.
• DO NOT obstruct the flow of combustion
and ventilation air.
Moving, Handling, and Unpacking
Remove and discard all packing materials,
including cardboard and tape on the outside
and inside of the range.
Remove the cardboard top pack containing
the burner heads, burner caps, grates, leveling
legs and anti-tip bracket from the top of the
range.
DO NOT discard the anti-tip
metal brackets (2) supplied
with the range. These are the
anti-tip devices and one must
be installed with the unit.
Refer to “Anti-tip Device
Installation” section.
Some stainless steel parts
may have a plastic protective
wrap which must be peeled off. The interior
should be washed thoroughly with hot,
soapy water to remove film residues and any
dust or debris before being used, then
rinsed and wiped dry. Solutions stronger
than soap and water are rarely needed.
NOTICE
DO NOT use the handle or oven door to
lift the oven. Remove door before
installation to ensure that it is not used to
lift the unit. DO NOT lift or carry the door
by the handle.
Removing the door must be done by your
dealer, a qualified licensed plumber, or
certified gas installer.
Door Removal
CAUTION
Avoid any damage to oven vents. The vents
need to be unobstructed and open to provide
proper airflow for optimal oven performance.
CAUTION
The cooling fan should be operating when
the unit is in operation. If you notice the
cooling fan is not operating or you observe
unusual or excessive noise coming from the
cooling fan, contact a Viking Authorized
Service Center before continuing operation.
Failure to do so can result in damage to the
oven or surrounding cabinets.
1
Open door completely. Place pins, supplied
with unit, in pin holes. For personal safety, ONLY use
pins supplied with the unit.
2
Remove hinge trim screws. Take off hinge trim. Identify
right and left hinge for future re-installation.
3
Gently close until pins stop door.
4
Lift door up and out.
Loading ...
Loading ...
Loading ...