Loading ...
Loading ...
Loading ...
3. Remove merchandiser or stainless cover from upper front of dispenser.
4. Remove four hex nuts holding chute to dispenser, using a 3/8” nut driver or socket.
5. Remove chute from dispenser.
6. Apply a very thin bead or RTV to the back of the diverter mounting plate.
7. Place ice diverter plate onto the four mounting studs on the dispenser.
Note: Flange of diverting plate extends into storage hopper.
8. Position restrictor plate over diverting plate, adjust so
that at least 1 ½” inches of space is open below the
bottom edge. Full open will provide maximum ice flow,
any less than 1 ½” will restrict ice.
9. Reinstall gasket and ice chute. Do NOT overtighten
nuts.
10. Open front of electrical cover of dispenser, locate
circuit board. Adjust motor on time to a half second*,
adjust off time between agitation to every 3 hours.
11. Reconnect power, agitator should cycle a half second*. Check ice shutter
operation.
12. Return merchandiser or cover to unit.
* On beverage dispensers, set motor on time to 2 seconds.
11/2"
Set full
CCW*
Set full CW
Restrictor
Plate
Chute
Opening
ID150, ID200, ID250
ICE DI VERTER KIT
June 2016
Page 8
Loading ...
Loading ...
Loading ...