Loading ...
Loading ...
Loading ...
5
Location Requirements
■
■
■
■
■
■
■
■
■
■
Window Installation
If AC is Blocked by Storm Window
Before You Begin
Window opening measurements:
A Cabinet louvers.
A
IMPORTANT: Observe all governing codes and ordinances.
Check the location where air conditioner will be installed. Proper
installation is your responsibility. Make sure you have everything
necessary for correct installation.
The location should provide:
■
Do not use an extension cord.
The appliance shall be installed in accordance with
national wiring regulations.
conditioner is installed.
Add wood as shown, or remove storm window before air.
or slots are not caulked or painted shut. Accumulated rain
water or condensation must be allowed to drain out.
If storm window frame must remain, be sure the drain holes
■ Free movement of air in room to be cooled.
■ A large enough opening for the air conditioner.
NOTE: Cabinet louvers must not be obstructed. Air must be able
to pass freely through the cabinet louvers.
IMPORTANT:
IMPORTANT:
These instructions are for a standard double hung -
window You will need to modify them for other.
types of windows .
The air conditioner can be installed without the
side curtain panels if needed to fit in a narrow
window See the window opening dimensions. .
All supporting parts must be secured to firm
wood masonry or metal, .
The electrical outlet must be within reach of the
power cord .
Follow the dimensions in the table and
illustration for your model .
A
( )With side curtain panels
B
Models A B
6K BTU
6K E-star
8K BTU
10K BTU
12K BTU
12 2 (315mm) min/5"
15 1 min /5" (386mm)
13 3 (345mm) min /5"
22 (559mm) - 37 4 (960mm)" /5"
24 9 /10" (632mm) - 39 (991mm)"
24 1 - 39 /2" " (622mm) (991mm)
Read these instructions completely and carefully.
Save these instructions for local inspector’s use.
Observe all governing
codes and ordinances.
Note to Installer:
Be sure to leave these
instructions with the
Consumer.
Note to Consumer: Keep these instructions for future
reference.
Skill level: Installation of this appliance requires basic
mechanical skills.
Completion time:
Approximately 1 hour.
We recommend that two people install this product.
Proper installation is the responsibility of the installer.
Product failure due to improper installation is not
covered under the Warranty.
You MUST use all supplied parts and use proper
installation procedures as described in these
instructions when installing this air conditioner.
Board
thickness
as required,
for proper
pitch to rear,
along entire
sill. Fasten
with nails or
screws.
Storm window
frame or other
obstruction.
sash
1-1/2"min
(38 mm)
Loading ...
Loading ...
Loading ...