Loading ...
Loading ...
Loading ...
Page 9 of 12
MAINTENANCE
CLEANING
ATTENTION: Please turn off the appliance and disconnect from the mains before cleaning or
performing any maintenance.
CLEANING THE SURFACE
• Clean the plastic housing with a duster or a soft wet cloth.
• Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause irreversible
damage.
• Make sure no water enters the control panel.
CLEANING THE WATER TANK
• Unplug the appliance
• Drain the water reservoir and refill with fresh water
• Doing this at least once a week will help reduce any mineral
deposits and keep the filters clean.
• Do not run the unit in cooling mode with stale water in the
tank.
MAINTAINING AND CHANGING THE HONEYCOMB FILTER PADS
The appliance is supplied with a set of 3 honeycomb cooling / filters pads (back and sides). The
cleaning frequency for the honeycomb filters depend on local air and water conditions. In areas where
the mineral content of the water is high (hard water), mineral deposits may build up on the honeycomb
filter and restrict air flow. If mineral deposits remain on the honeycomb pads, the filter should be
washed under fresh water. We recommend cleaning the honeycomb filter at least every two months,
depending on your needs.
For best results, allow the honeycomb filter to dry after each use by turning off the cooling function
for 15 minutes (with empty water tank) before turning the unit off.
END OF SEASON MAINTENANCE
1. Empty the tank and wash it.
2. Allow the tank to drain and clean the Honeycomb pads
3. Cover the unit and keep it in a dry place.
Loading ...
Loading ...
Loading ...